spacer bars

Spacer bars are used to maintain covering between the same layer reinforcement bars of the reinforcement work. When two layers of the top or bottom reinforcement layer, spacer bars are applied between them. In this case, most of the time use a 25 mm diameter piece of reinforcement bar as a spacer bar.






Comments

Post a Comment

Popular posts from this blog

Standard gauge box size for measure the cement and aggregate

Image
The internal dimension of  the gauge box for measuring aggregate is 400 mm x 350 mm x 250 mm (which is 0.035 m³ and corresponds to the volume of a 50 kg bag of cement and dry volume sand is used for proportioning) The internal dimension of the gauge box for measuring cement is 400 mm x 350 mm x 290 mm (This volume is equal to a 50 kg bag of cement)         GAUGE BOX
Read more

Portal beam structures

Image
Portal beam Portal beam structures eliminate the necessity for interior columns, allowing the entire floor area to be utilized without obstructions. This provides greater flexibility in layout and design. Additionally, they facilitate the movement of people, machinery, and goods, which is especially important in factories, warehouses, and retail spaces. This makes the building future-proof, as it can accommodate various uses over time without significant structural changes. Load transfer Vertical loads                                                                                                                                            ...
Read more

BLOCK CASTING IN SRILANKA

Image
BLOCK CASTING Generally, a ratio of 1:4:5 ( cement : sand : coarse aggregate ) is used for block casting for government construction works in Srilanka. The mixture is poured into moulds of desired shapes and sizes. These molds can vary based on the intended use of the blocks.  The blocks are kept moist for a specific period of time after they are cast.  Curing is an important phase in the manufacture of concrete blocks, and effective processes can result in considerable increases in strength and durability. CURING FOR BLOCK CASTING the blocks should be completely submerged in water for at least 3 days. For at least seven days after removing from the submerged wate r,  hessian cloth   or something similar is used to cover and curing the block to retain wetness and prevent water loss due to hydration. However, for better impacts, it can be extended up to 14 days.
Read more